1.Design

With the help of modem designing softwares,such as AutoCAD,PKMK,3D3S,TSSD,

SAP 2000,TEKLA Structures(Xsteel),3DS MAX,we provide full designing and detailing service to all customers.

Basic Building Parameters we take into consideration

Building width

No matter what primary framing system is used,the building width is

defined as the distance from outside fo eave strut of one sidewall to

outside of eave strut of the opposite sidewall.Building width does not

include the width of Lean to buildingS or roof extentions

End Bay

Length

The distance from outside of the outer flange od

end wall columns to center line of the first interior

frame column

Buidling Length

The longitudinal length of the building measured from out to out of

end wall steel lines

Interior bay

Length

The distance between the center lines of two

adjacent interior main frame columns.the most

common bay lengths are 6m,7.5m and 9m

Buidling Height

Building height is the eave height which usually is the distance from

the bottom of the main frame column base plate to the top outer

point of the eave strut.When colomns are recessed orelevated from

finished floor,eave height is the distance from finished floor level to

top of eave strut

Design Loads

Design for snow loads,earth quake loads,collateral

loads,crane loads or any other loading condition,if

required must be specified at the time of request

for quotation

Roof slope(x/10)

This is the angle of the roof with respect to the horizonal.The most

common roof slopes are 0.5/10 and 1/10.Any practical roof slope is

possible.